Re: Cincinnati Arrow 750 Spindle Speed Error CT Control
Originally Posted by
Heavyload_1
Hi All,
I have just fitted a brand new Spindax Spindle drive on my machine(the old 1 lost all its smoke in a bang)
I swapped it out, checked mains in, motor isolation etc. Changed the keypad, so should swap all settings to new drive?
I have an error "SPINDLE DEC TO ZERO TIME" I can delete error, boot servos up, align machine etc.
G code run X,Y,Z fine, M3/4/S command start spindle, the spindle runs, however the speed is only 25% of command input(If I program 1000 I just get 250rpm) The readout is showing the actual spindle speed, after the 10 seconds, it trips due to error and comes up "SPINDLE ACC/DEC TIME"
Am new to these machines, so any advise would be appreciated? I can get into all parameters on machine conterol and know how to change settings in Spindax, but have hit a bit of a wall with it?
Regards John
Looks like the gear ratio need to be set.
http://cncmakers.com/cnc/controllers/CNC_Controller_System/CNC_Retrofit_Package.html