hi any good gcode test programmes on here to give my new machine a running in period thanks
small m/c x750mm y430mm z65mm max travel thanks.
hi any good gcode test programmes on here to give my new machine a running in period thanks
small m/c x750mm y430mm z65mm max travel thanks.
What exactly do you want your machine to do to run it in.
How many times do you want it to do it.
What feedrate do you want to use.
When I built my plasma table there was no reason to "run it in", but I did want to check for lost steps after a lot of randon XY moves at rapid speed. All I did was draw a load of zig zaggy lines in cad, and set the table running. My table is 2500 x 1500 so I could fit quite a few lines in, and the test run went for 10 mins.
We can't understand your problem. please explain .
If you want to details knowledge about G - code & operating follow this link - https://www.hdknowledge.com/2017/12/g-code-in-cnc.html
I know someone on the Joe's CNC forum created a Mach3 run in wizard.
The reason was because they use V bearings on angle iron, and used the run in to "pre-wear" the angle iron.
There's no need to "run in" a machine built with any standard type of linear motion components.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
hi thanks for reply just wanted the machine to run on all axis check the steps
I have no cad programmes as yet or gcode generators thats my next phase thanks noworries