I have a Hurco KM3 that i need to send some boards out for repair. Any ideas on who still works on these machines. My machine is in very good shape and I am very well versed in its operation. I just want to get it back up and running.
I have a Hurco KM3 that i need to send some boards out for repair. Any ideas on who still works on these machines. My machine is in very good shape and I am very well versed in its operation. I just want to get it back up and running.
With the number of modern control conversions going on, perhaps you could get some surplus boards from a convertor ?
They use to be listed on ebay a few years ago and maybe contact some on this board that also have done the conversion.
The only source I know of besides Hurco is a repair shop called Midwest CNC
Midwest CNC Service, Inc.
I still have all my stuff from my retrofit.
I went with a mach3 conversion back around 2010-2011.
Buddy Maughn in Florida checked all my boards and sent them back.
It turned out that my wiring harness was cracking, and breaking down.
I still have the drive boards, if you are interested.
Will sell cheap.
I think I have 5 or 6.
You can PM me, or send message one here.
I also have all manuals, micro-tapes, etc.
Jackal
Everything is bio-degradable, if you run over it enough times with the lawnmower.
Everything is bio-degradable, if you run over it enough times with the lawnmower.
I am getting back into this project. I am still looking for someone to help get it back up and running. When power is turned on the fans come on but that's all i get.