Hello sinha and mactec54,Originally Posted by mactec54
In the way you can combine Absolute and Incremental with a lathe control, (G00 X100.0 W-30.0) so are you able to do the same with a mill control using G90 and G91 in the same Command Block. The following example is quite legal and results in a combined Absolute move to X100.0 and an Incremental move of Y-10.0.
G00 G90 X100.0 G91 Y-10.0
One caution that should be observed is that on completion of the above example Block, the control will be in G91 (Incremental) Mode.
Regards,
Bill