Getting proper preload on cheap AC bearings might be more difficult though. Matched AC bearings usually have the inner faces (the face pointing at the other bearing) of the races ground so that when the pair are installed tightly in contact with each other they will have proper preload.
Thread: Ballscrew Basics
Results 1 to 20 of 138
Threaded View
-
10-22-2018, 02:55 PM #29
Registered
- Join Date
- Jun 2011
- Posts
- 692
Re: Ballscrew Basics
Reply With QuoteSimilar Threads
-
The basics
By SpacedCowboy in forum Community Club HouseReplies: 0Last Post: 01-23-2012, 08:05 PM -
Another which is better R&P,Ground ballscrew,rolled ballscrew,Acme,beltdrive etc.thre
By lgalla in forum Linear and Rotary MotionReplies: 10Last Post: 01-16-2007, 06:27 PM -
The basics
By Netjams in forum Community Club HouseReplies: 2Last Post: 04-10-2006, 09:01 PM -
The Basics Please -- Help!!!!
By Starwoes in forum CNC (Mill / Lathe) Control Software (NC)Replies: 3Last Post: 09-08-2005, 05:25 PM
Tags for this Thread
$12,
0.200,
adequate,
almost,
already,
another,
asking,
attributed,
available,
ballscrew,
cnc,
cnc.,
deeply,
diffuser,
doi,
down,
engineered,
enters,
everyone,
far,
firmly,
ground,
guessed,
heats,
importantly,
keep,
killer,
look,
mos,
non,
not,
opera,
ques,
races,
recirculating,
said,
say,
since,
then,
wan,
whatever,
within,
worthless
Posting Permissions
