Just tried to install version 1.2047 and run it in demo mode and got this error. Anyone else got this problem?
Just tried to install version 1.2047 and run it in demo mode and got this error. Anyone else got this problem?
If my post is missing an 'nt you might have to add it yourself.
No.
Did you create a new profile? If you changed the screenset name in your profile, you may have a spelling error or other typo?
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Nope all I did was click the setup_1.2047.exe file, Next, accept the agreement, default location (C:\UCCNC).
I took the X out of Overwrite the default UCCNC profile and macros (recommended) just in case it overwrote my existing config accidently.
and installed. OK and finish. Choose a demo device and continue when the message came up.
Just went through the installation again putting a X in the Overwrite the default UCCNC profile and macros (recommended) and no error came up.
Would seem that is not very "optional" if it won't allow the program to start.
If my post is missing an 'nt you might have to add it yourself.
I haven't heard of this happening to anyone else, and without seeing your original profile, can't tell you what the problem was.
I highly recommend creating a new profile to use, and NOT using the default profile. That way you never have to worry about any of your settings being overwritten during updates.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)