Re: New to the Okuma lathe with a U10l control
Originally Posted by
newton11n
Ok I tried this although it did not produce an error it did not cut threads either it basically acted like a turning program
this may be because it cutted only the 1st pass on the thread, thus a single G32 will only go once towards Z-
to cut the thread, you need all G32s, and in each one you may need both x&z
so :
Code:
(01156.MIN)
N10 G50 S2000
N11 G0 X400.
N12 G0 Z400.
(THREAD1)
N13 T020202
N14 M8
N15 G94
N16 G97 S500 M3 M41
N17 G0 X2.8 Z0.1969
N18 G0 Z0.3181
N19 G1 X1.9496 F39.3701
N20 G32 X1.9496 Z-1.2431 F0.0787
N21 X2.065 Z-1.3009 F0.0787
N22 G0 X2.8
N23 Z0.3181
N24 G1 X1.9311 F39.3701
N25 G32 X1.9311 Z-1.2339 F0.0787
N26 X2.065 Z-1.3009 F0.0787
N27 G0 X2.8
N28 Z0.3181
N29 G1 X1.9168 F39.3701
N30 G32 X1.9168 Z-1.2268 F0.0787
N31 X2.065 Z-1.3009 F0.0787
N32 G0 X2.8
N33 Z0.3181
N34 G1 X1.9049 F39.3701
N35 G32 X1.9049 Z-1.2208 F0.0787
N36 X2.065 Z-1.3009 F0.0787
N37 G0 X2.8
N38 Z0.3181
N39 G1 X1.8943 F39.3701
N40 G32 X1.8943 Z-1.2155 F0.0787
N41 X2.065 Z-1.3009 F0.0787
N42 G0 X2.8
N43 Z0.3181
N44 G1 X1.8943 F39.3701
N45 G32 X1.8943 Z-1.2155 F0.0787
N46 X2.065 Z-1.3009 F0.0787
N47 G0 X2.8
N48 Z0.1969
N49 M9
N50 G90 G0 X400. Z400.
N51 M2
also, like mr wizard said, try G33 instead of G32, and all stuff from post #14
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg