[matth]

This is interesting.
I just received my MB2 today with the intention of doing as you did with a UC300 and making up a small adapter plate with acrylic.
This will make a much better overall solution so I will definetley be buying one of these once they are available.

Thankfully I have an ESS which I can drop onto the MB2 later so that it doesn't go to waste.

[vrasak]

Hi friends,

Firstly, thank you to Gerry who inspires me to make a good looking breakout board for UCCNC software and its UC300ETH.

I received 20 pieces of prototype PCB back from the manufacturer 2 days ago. Today, I’ve managed to have my first UB1 prototype. I spent almost a whole day to setup my PNP (pick n place) machine and made a board as shown in the attached pictures.

Next few days I will test UB1 board and hope that I wouldn’t find any mistake. The following is the areas I want to test.

• Noise generating and immunity.
• Heat dissipation
  
• Current consumption on DC2DC converter.
  
• Functional in various circuits.

Thanks
Wee
www.CNCRoom.com

[xillianto]

Hi friends,

Firstly, thank you to Gerry who inspires me to make a good looking breakout board for UCCNC software and its UC300ETH.

I received 20 pieces of prototype PCB back from the manufacturer 2 days ago. Today, I’ve managed to have my first UB1 prototype. I spent almost a whole day to setup my PNP (pick n place) machine and made a board as shown in the attached pictures.

Next few days I will test UB1 board and hope that I wouldn’t find any mistake. The following is the areas I want to test.

• Noise generating and immunity.
• Heat dissipation
  
• Current consumption on DC2DC converter.
  
• Functional in various circuits.

Thanks
Wee
www.CNCRoom.com

Looking good this will be a good pick foe me when doing the change to uc300eth and uccnc.. just have to get the incime for it first (i mainly let the machine pay for itself)

Sent fra min SM-G930F via Tapatalk

[matth]

Put me down for one of these once you are happy.