[Mike 1948]

Personally, since you are just getting started, rather than running through the scaling issues I would start with the desktop version. Try it for awhile till you are comfortable and actually need the 36 inch job then upgrade. It costs the same and can be done in an hour or so. Good luck and enjoy

Mike

[louieatienza]

Personally, since you are just getting started, rather than running through the scaling issues I would start with the desktop version. Try it for awhile till you are comfortable and actually need the 36 inch job then upgrade. It costs the same and can be done in an hour or so. Good luck and enjoy

Mike

I was asked LOL... though doing that would be kludge. The thing is, just because one has a 36 x 24 table doesn't mean that the entire table can be accessed. I agree that I wouldn't worry about it until it's needed. As a guy who paid a LOT of money as a hobbyist for a CAM system (aside from VCarve Pro which I also own along with Cut2D) I'm not one to circumvent anything myself though it's not hard to figure it out... it's a Filipino thing...

[Tomcat104]

Thanks Mike.