[quadtard]

We have a group of older Mitsui Seiki HU40A horizontals, 3 of them have Fanuc 15M controls. One of the controls was reflashed with an old parameter file, and now the control is limiting the program directory to only hold 100 files. It used to hold 1000 file entries. Memory still shows it is there, it is just like there were a parameter that is altered to limit entries to 100. Anybody know if this is a parameter that I can change to get it back to 1000? I barely have enough entries to house my probing routines, let alone cut anything.

[STLMachinist]

it is an option parameter. if you have the original data sheets or parameter list, it can be reinstalled by FANUC. you can most likely find the option bit by searching online. No one will post it on the forum tho. it's FANUC proprietary info.

[memoryman]

I can tell you how to do that at no cost if you call me 289 389 6117