I have tried everything I can think of to fix the issue
I bought this kit off ebay US Free! Wantai 3Axis Nema34 Stepper Motor Dual Shaft 1600oz-in&Driver 7.8A CNC | eBay
This may be my mistake to start with...
https://youtu.be/g5CCSTHG9co
This is the video of the issue. If you turn up the sound, you can hear the motor BUMP or skip a little every 10 secs or so but then it will just start grinding and stall. It stalls on all axis no matter if you go slow or fast speed but can only get 80 IPM out of the motors without missing a bunch of steps.
Things I have tried,
Tested all power supplies 60VDC good
Checked all wiring
Changed setting on drives with amps (3.5 amps) to pules per inch (right now set at 2730)
Attachment 359140
I see where other people was having issues with the Breakout Board so I bypassed the optoisolation on the board.
My question is, do I need a new Break out board and which is the best to get or do I need something else
I lean to the break out board because all motors will stall at different times
What do you guys think.