Re: Looking to pull the CNC conversion trigger
The few key dimensions I worked around was to make sure the opening was slightly lower then my table. And that the width of the door would allow me to run a piece out the sides, as deep as my table at the min/max y travel extents.
One door design I considered, was a vertical slide in window. But in the end I went with weld on hinges, that I could lift off the frame. I still need to add a latch system.
Work: Hurco VMX42/VMX50 - Shopsabre 4896 - Bobcad V4 4axis pro
Home: RF45 with Ajax CNC Controller - Bobcad V27 3 axis pro