Is the patriot a stepper controlled machine? If so the instructions are at this link under the section "2. Start Page". There is an import option.
Stepper Configuration Wizard
Thread: Mach3 to Linuxcnc
Results 1 to 19 of 19
Threaded View
-
07-14-2016, 08:11 PM #6
Registered
- Join Date
- Jan 2005
- Posts
- 1943
Re: Mach3 to Linuxcnc
Reply With QuoteSimilar Threads
-
Smithy CNC 1240 spindle configuration in Mach3 or arrow key fix in LinuxCNC
By Arnbjorn in forum SmithyReplies: 2Last Post: 05-02-2017, 03:26 AM -
Want to go from mach3 to linuxcnc - knee mill running in a job shop
By extsuba in forum LinuxCNC (formerly EMC2)Replies: 4Last Post: 03-09-2016, 07:18 PM -
Mach3 vs LinuxCNC vs USBCNC vs CNCUSB
By emptystr in forum CNC (Mill / Lathe) Control Software (NC)Replies: 2Last Post: 05-08-2015, 03:49 AM -
grbl vs mach3 vs linuxCNC
By speed_racer in forum Benchtop MachinesReplies: 0Last Post: 05-08-2015, 02:37 AM -
Setting up pwm signal for Spindle in Mach3 - copying setup from emc/linuxcnc.
By craynerd in forum Mach Software (ArtSoft software)Replies: 0Last Post: 04-17-2012, 08:00 AM
Tags for this Thread
Posting Permissions
