Over the last couple of days I have done most of the cabling required for the estop and enable circuitry, getting ready to transplant into the machine, most of the wiring is done, except for a few things that will need to be hooked up once it all goes in.

Today I powered up the Z axis drive as it has its own power supply and connected the line driver with a Cat5 patch lead to see if it works, after forgetting to put the enable jumper in the drive to make it actually fire the power units it all works perfectly.

Doesn’t look much in the photo but it took a lot of work to get that stupid little blue led to light up !

Russell.