I tried to start up my Hurco BMC30 after the Linux CNC retrofit and my servopacks are in a baseblocked condition.
I am now to the point where I am trying to get the servos going and have hit a roadblock. On the 8 segment display I have the center mark lit up indicating a baseblocked condition, turning the servos off. I have 24vdc in on 7, 8 is grounded through the SSR's on the PPMC. The alarm circuit has 24vdc going to it and the other side of the alarm circuit grounded. The relay that is in the alarm circuit is picking up indicating that it is not in an alarm condition. The limit switches that block a direction are both closed which should allow the servo to run in either direction. But the servopack is still mad as it is in a baseblocked condition.
Any ideas?
Thanks!