[mountaindew]

Was this code you wrote or is it from a cam program? If a cam which one?

Sprutcam spits out some code that PP chokes on now and then. Although it does generate errors or warnings something like start and end radius error .
I have run into this issue with hsm tool path option creating paths that generate these errors. The reason to mention this is the same code NOT ever run/executed only loaded, changed the operation of the mill in such a way it scared me! When I pushed the page down button the z axis took off and didn't stop until long after the button was released. This was same for x and y axis also. If I had probe in spindle and started to manually jog around to set a offset it would have damaged or destroyed probe. Was easy to fix by taking out the hsm ops in one area and no errors and then reload code and no crazy PP mill control behavior. Again all it took was to load code not ever run it! And all it took to fix problem was load code that does not generate the error!
Did not think this was possible!
Or is my understanding of program execution way off?