Hello again.
Run MDI mode, and a tool (like T2) with tool sensing activated and make sure that the machine will touch of the tool sensor.
Now you got a value for the tool T2 = 123.456(from tool sensor), now move the tool against the spoil board.
The machine shows a value 234.561. Positive value if the tool sensor is above spoil board and negative if it is below (not 100%sure). The difference between the above figures will be the height dif. between the tool sensor and spoil board. Then run Z-height touch off with the tool against the spoil board. Don´t use the Aux to anything!
Kanske blir lättare om jag skriver på svenska?
BR
Daniel