Re: Re-wiring a 2001 CNT Motion Systems Router on the data side.
Wow indeed. That is a lot of (great) work. Gfacer - unfortunately I don't think this is your issue at all or might it be? Its interesting though that when I think about it, my controller never does 3 axis moves - though I suspect its more like I never force my cam software to make them. Its pretty much always z down, then x/y cuts, z up, jog, repeat. Though now that I think about it some more, any cut with tabs would do it too...
I know you like to use the ramp in features more (which I assume would force mine too) which would be forcing these moves - at any rate you should definitely try and repeat the issue and Joe, you might want to post this at camaster's forum as see if they can repeat the issue on their wincnc set ups.
In case anyone is wondering, I'm the twin of the other gfacer on cnczone...