Originally Posted by
budgieW
MD1 is the controller memory, On a U10 control this directory will be very small. You can run the program straight from the TC directory. TC: is the server HD0; is the on board flash drive basically the same as a FANUC data server
Just use a *.SDF file that is stored in MD1, you can use this to call from any directory, samples below
PSELECT HD0:ROUGH.MIN (RUN FROM HD0 DIRECTORY)
PSELECT:ROUGH.MIN;S (THIS IS FOR CONTROL RUN METHOD S)
PSELECT TCA:ROUGH.MIN (RUN FROM TCA DIRECTORY)
PSELECT HD0:\O6001.MIN
END