Quote Originally Posted by PCW_MESA View Post
Pathpilot will very likely run faster than Mach before stalling for a number of reasons
...
So to do this you would have to work around this protection (just as you have done with Mach)
I can confirm that Pathpilot is definitely NOT slower than Mach3. I ran Mach at 145in/min for X and Y, 106in/min for Y (the numbers are odd due to conversion from metric). I have Pathpilot now running comfortably at 157.5in/min and 130in/min respectively. The limits are actually slightly higher for both Mach and PP but I backed off a little to ensure that I didn't run into any problems later. I don't cut at these speeds, I only use these values for rapids and jogging. I significantly increased the 4th axis speed under Mach 3 but I haven't tested this with PP yet.
Step