Hello,
I have a CNCdrive DG4S-08020 driver that I am trying to get to work with a servo motor off of a Bridgeport, without much luck.
I am able to load the Servoconfigurator3 software, get it to talk to the CNCdrive, tweak and download the PID tuning parameters, and analyse the drive, but no matter what values I try, the output always looks like the following (an immediate spike with no waveform there after):
Attachment 253166
When running these tests, the motor runs for 0.5 to 1 seconds before going into fault mode.
Does anyone have any suggestions on how to diagnose and debug this arrangement?
I am also uncertain where to start my PID tuning Ap, Ad, and Ai settings.