This does not makes sense, except if you fragmented the arc with low resolution.
This does not makes sense, except if you fragmented the arc with low resolution.
was years ago with what was meant to be a top of the line cad program what put out lots of not so tiny lines, what i use now put out a small code that use`s arc`s yes it`s tiny lines but it has bugger all code so its faster, cleaner and very time saving.
dubble I am not saying anything about your controller never used it just saying about what I have used and use now so nothing on you.
http://danielscnc.webs.com/
being disabled is not a hindrance it gives you attitude
[SIGPIC][/SIGPIC]
daniellyall,
That's ok, I did not think you told anything about our controller. I was just telling my opinion on your comment based on my knowledge in this theme.
And yes, you are right about that the code is then much longer and more calculations are needed, but today's computers can handle it, they are fast enough to deal with the task.
The original post I was replying to was about that the UCCNC currently does not understand the G18/G19 codes which is true and I thought to share with your the workaround...