Originally Posted by
jevs
Yes, I am not sure how that helps? Z still has a slower rapid than X and Y. That is the main concern I had. Don't want to over speed Z, but don't want to slow down X and Y. If you only get one setting for all 3, I have to assume you pick the fastest.
However if as ger21 says all G00 code rapid moves have no actual setting for the speed when used and the machine decides, then I am not sure what it uses this for. Maybe it only uses the Rapid Feed setting for simulation?? So it shows you in the real speed you might expect your machine to move.
I would assume it uses the Max Feedrate so it knows the actual limit it can ask a tool to cut.