Hi all,
I've been using Solidworks 2014 to make 3d models and then export them to Mastercam X5 for about 4 months now.
Recently, I noticed that when I export SW to MC, the surfaces when opened in MC have many facets which will clearly show up on the actual machined products.
(I export in *.x_t. <--maybe this is the problem?)
I also noticed that 2d curves(exported in *.dxf or *.dwg) show as very coarse lines(?) in MC...but this one I can always go around to make it work...
So basically my question is how to make the surface as smooth as they should be.
I searched around a bit and found a few people had the same issues, but no solutions...
I've looked at the options and configurations on both SW and MC but don't seem to find any answers yet.
Can anyone help with this?
Thanks in advance,
Ken