[ejkoeze]

I just scored 2 big Ametek DC motors but cannot find any specs online.
Can anybody shed some light?
~100mm dia ~180mm long

Ametek / Lamb Electric Div
799001-900 Rev.M
01A(E56617) 116249-00
72VDC Nominal
221185F7

What I particularly look for is torque/rpm, power / suitable as servo?

Erik Jan

[bill south]

Hey Eric;
How goes it???? I do not have the specification for your particular motors but similar ametek motors are listed at the camtronics-cnc site. The voltage is different but the specs may be similar. Just put an encoder on the back of them, slap a little juice (voltage) to them and torque them up!!! I think you'll be impressed!
I actually have three ameteks on the shelf for a future project. However, they still must be modified for an encoder shaft!!! Big old honkers they are!!!
Good Luck
billyjack
Cheers!
BTW, was in amsterdam on holiday a few years ago. Awsome!

[ejkoeze]

Hi Bill,

Things are well. I have found a couple of new (4 pole) servo's that I'm gonna hook up to my BF20 mill.

The Ametek motor's I have are a bit bigger though. I'll wait and see if somebody else turns up anything usefull.

Erik Jan