Anywhooooo...
I've been machining the outer housing from the 4" bar stock and made a start on the jig plate for machining the reverse side of the outer housing and motor plate.
Thread: Minimill to 4th Axis....
Results 1 to 20 of 48
Threaded View
-
01-31-2015, 06:27 PM #17
Registered
- Join Date
- Aug 2005
- Posts
- 180
Reply With QuoteSimilar Threads
-
MiniMill(Haas)
By smallplanes in forum Haas MillsReplies: 4Last Post: 11-16-2011, 07:54 PM -
-->Completed setup minimill-- X,Y ok.. BUT Z-AXIS has problem--- Need advice!!!
By cjchands in forum MetalWork DiscussionReplies: 2Last Post: 11-15-2006, 10:05 PM -
-->Completed setup minimill-- X,Y ok.. BUT Z-AXIS has problem--- Need advice!!!
By cjchands in forum Hobbycnc (Products)Replies: 0Last Post: 11-15-2006, 07:17 PM -
Minimill Comparison
By Hack in forum Benchtop MachinesReplies: 2Last Post: 02-22-2006, 06:42 PM
Tags for this Thread
Posting Permissions
