Hi all,

Ok, I bring back this thread from the dead!
2 years already!
Just to follow up on my Laser machine, if some are interested.
I am still very happy with it, and the machine is performing flawlessly! Not a single issue, rock solid!

And of course, I have a question for the Gweike / WKLaser team.
I would like to change the tube from 80W to 100W. I believe this is possible in my machine (this was an old discussion!).

Also, as I read back the thread, especially about cutting aluminium, I had a chat with Tina at the time after some of the posts, and she did indeed confirm that it was not possible with 80W, or even 100 While some European manufacturer were still saying that I could. I tried, out of curiosity, and I can't. Just to correct the facts on the thread.

Anyway, all in all, after 2 years of good service, very very happy with my choice of machine, and if I had to buy a second one (hopefully!), this will be from the same people.

Fred