[RCaffin]

I have a new power supply that I wanted to test. I wired up the servo that had the noise. Ran the
servo and no strange noise at all. Does this tend to mean it could be a tuning issue. The test did NOT
include the motor connected to the 320 Gecko. Also both the new and the old motor are making the
same noise when I run G code. I assume again its a tuning or EMI interference problem.

I'm sorry, but I could make very little sense out of what you have written.
I was under the impression that it was a motor which was making the noise, not the servo.
Are you saying that the test you ran with your new PS included just the PS and the Gecko, but no motor? Or what?
I'm confused.

Cheers
Roger

[Larken]

I'm sorry, but I could make very little sense out of what you have written.
I was under the impression that it was a motor which was making the noise, not the servo.
Are you saying that the test you ran with your new PS included just the PS and the Gecko, but no motor? Or what?
I'm confused.

Cheers
Roger

Me too... Is Novett ,bgolash they guy who posted the video ? Huh ?