the DC servo is the spindle motor. Couldn't I just use that as is?
for the C-axis I'll (later) use an auxilary servo. (and belt drive)
for the axis' (X/Z) movement I might change to Nema34 stepper motors?
- I can use the stepper drivers if it has step/dir and if not I'll change them too
-right?
...anything I've missed?
Results 1 to 20 of 35
Hybrid View
-
10-17-2014, 06:18 PM #1
Registered
- Join Date
- Sep 2014
- Posts
- 51
Re: CNC Lathe controlled with OLD! PC, can I change the PC and SOFTWARE??
Reply With QuoteSimilar Threads
-
Find Software for Z zero after tool change
By Mr.Chips in forum Calibration / MeasurementReplies: 3Last Post: 01-12-2012, 03:31 AM -
Fanuc O-TD-controlled lathe machine at low speed and fixed speed problem.
By bursa017 in forum FanucReplies: 0Last Post: 06-11-2010, 07:59 AM -
I want to change my software ?
By eng_semsem1980 in forum Screen Layouts, Post Processors & MiscReplies: 0Last Post: 07-10-2007, 06:36 AM -
cnc controlled mandrel bender controlled by mach3
By timmyb199 in forum Bending, Forging, Extrusion...Replies: 5Last Post: 05-31-2007, 12:35 AM -
Software change request
By widgitmaster in forum Mach Software (ArtSoft software)Replies: 2Last Post: 11-26-2005, 03:38 AM
Tags for this Thread
axis,
boxford,
cad,
cad/cam,
cam,
cnc,
cnc lathe,
control box,
control system,
controller,
db44,
electronics,
lathe,
lathes,
machines,
mill,
parallel,
parallel port,
post,
programming,
rolling,
software,
tool,
updating
Posting Permissions
