Re: DC servo hot plus strange ringing noise
Originally Posted by
Novett
Hi
I have a new power supply that I wanted to test. I wired up the servo that had the noise. Ran the
servo and no strange noise at all. Does this tend to mean it could be a tuning issue. The test did NOT
include the motor connected to the 320 Gecko. Also both the new and the old motor are making the
same noise when I run G code. I assume again its a tuning or EMI interference problem.
Are you taking about the same motor as the OP, bgolash ? Or is this a different problem.
Manufacturer of CNC routers and Viper Servo Drives
www.LarkenCNC.com and www.Viperservo.com