I cut the 1/50 2 wire just behind the cnc output of plasma and i plug directly on the thc, and same thing.... i cry....
I'm very disapointed of the results....
yet all are supposed to be ok for good result...
Maybe plug directly on the output, just before enter on the cable...

I plug directly on the electrode like old school and read OK !!!
But are very more difficult to make a plug for all that...
need 8 input on plasma ( 4 for in and out of thc +2 for 12V, and 2 for trigger on/off... )

If the output of plasma was OK to drive the thc, only need 4 wire to plasma...

Which ARC OK are better, proma thc or plasma signal ?
i think are Thc, normally I think are better place to know when are ok...

in description of my Everlast 80S
( Features & Benefits: Easy starting with Blow Back Pilot arc allows easy cutting of rusty and painted metals)

Are not supposed to be Hard for Electronic, Maybe JimColt can confirm that for me....

Thanks