587,101 active members*
4,601 visitors online*
Register for free
Login

Thread: Auto thread Problem

Results 1 to 2 of 2
  1. 08-11-2014, 08:47 PM #1
    Hydratight
    Hydratight is offline Registered
    Join Date
    May 2014
    Posts
    16

    Auto thread Problem

    I have a Mit FX10K and when it goes to auto thread is starts and the wire gets to the aspirator and alarms out. If the operator is there and hits stop and does a manual feed and manual collect to get it past the aspirator it will run. Any advice would be appreciated.

    Thanks Dan
    Reply With Quote Reply With Quote
  2. 08-13-2014, 04:50 PM #2
    Hydratight
    Hydratight is offline Registered
    Join Date
    May 2014
    Posts
    16

    Re: Auto thread Problem

    FYI the wire from the aspirator to the machine had worn thu inside the transition tube. I cut and spliced togeather and works again
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. auto reset problem in Mach3
    By kievari in forum Stepper Motors / Drives
    Replies: 2
    Last Post: 07-09-2012, 06:51 PM
  2. Torch Auto On/Off timing Problem
    By Eijazz in forum Torchmate
    Replies: 4
    Last Post: 05-24-2010, 05:33 PM
  3. Auto-Off a problem with the Xbox 360-Wireless-Controller?
    By Spartan117 in forum Mach Wizards, Macros, & Addons
    Replies: 0
    Last Post: 08-07-2009, 07:43 PM
  4. Auto Tool Zero VB problem
    By Normsthename in forum Mach Wizards, Macros, & Addons
    Replies: 0
    Last Post: 11-23-2007, 05:15 PM
  5. bestline auto feed problem on a series 2
    By brownandsharp in forum Bridgeport / Hardinge Mills
    Replies: 2
    Last Post: 07-27-2006, 11:01 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules