I'm extremely confused with the "x dia. measure" feature. I sure hope someone can enlighten me as I've spent the best part of the day on this. I have a gang tool set up on the TL-1 lathe with 4 place turret. After setting up the first tool to center drill everything worked fine.
After centering the second tool, a drill bit, and pressing the "x dia. meas." button the correct x offset is entered in the offset block initially, but the screen prompts to enter the diameter. After entering the diameter the value changes, which locates the drill off center. I'm new to Haas and really like what I see so far, but this really has me confused.
Really grateful if someone could enlighten me with this situation.
AJ