I need to buy an 8 inch floppy disk of ''operating system program II-A V3.01e-B"software of OKUMA CNC MILLING machine 500M-G. I would like to appreciate for your immediate response of mail.
Best Regards
Desale
Results 1 to 2 of 2
-
05-31-2014, 01:55 PM #1
Registered
- Join Date
- May 2013
- Posts
- 8
''operating system program II-A V3.01e-B"software of OKUMA CNC MILLING machine 500M-G
-
05-31-2014, 03:42 PM #2
Gold Member
- Join Date
- Feb 2009
- Posts
- 6028
Re: ''operating system program II-A V3.01e-B"software of OKUMA CNC MILLING machine 50
Okuma only. They will send it on 3.5 floppies, and you will need the local service group to come out with the 3.5 drive kit to install it. Going to be very expensive.
Sent from my G-Tab Quantum using Tapatalk
Reply With QuoteSimilar Threads
-
Operating System software
By cncadmin in forum Computers / Desktops / NetworkingReplies: 0Last Post: 06-13-2012, 05:55 PM -
software for 64-bit operating system
By Z.K. in forum CNC (Mill / Lathe) Control Software (NC)Replies: 6Last Post: 01-08-2011, 10:18 PM -
CNC Software and operating system
By jeffmorris in forum CNC (Mill / Lathe) Control Software (NC)Replies: 15Last Post: 03-06-2008, 10:33 PM -
What's the best operating system & software for CNC mill?
By Appalachiatools in forum Computers / Desktops / NetworkingReplies: 3Last Post: 04-25-2007, 12:25 PM
Tags for this Thread
Posting Permissions
