Since I will use Mach 3, I think I need some help with this.
Someone said that, limit switches aren't needed. I can grasp that, just don't try to machine a profile that's bigger than your envelope. So, as I get my machine ready to test and tune I am confused and struggling to understated these things so far.
One, How do I start and stop a machine session in the same place?. Let me illuminate.
I want to be able to, start the tool movement at a point, off and away, from the material piece I wish to cut, and then when the machine is done cutting
I want to stop the tool movement at that same place.
Two, What is a Zero Setter and how do I make one and connect it to Mach 3?.
If I want to use the position of the Zero Setter as my start and stop position how can I accomplish this?