Hi to you all, having a bit of a problem with the Fanuc Controller on a Dah Lih Machining Centre. The system does not seem to recognise the L0 on the end of a drilling cycle and therefore drills a hole where I don't want one. e.g.
N10 G00 G56 X0. Y0. S1000 M3 (bolt hole centre)
G43……...
G81 G98 Z-0.1 R0.1 F2.0 L0
M98 PXXXX (hole positions)
I know I can avoid this problem by positioning the tool over the first hole on the N10 Line but there are times such as when using macros that I prefer to position the tool over the bolt hole circle centre.
Has anyone else experienced this problem or know why it is happening?
Many thanks.