hello all,
can anyone tell me what may be the problem for following sequence of events:
1. i have connected leadshine m752 drive with breakout board and switched it on.
2. the green led indicator of drive was on showing normal power on.
3. i did not connect the motor(actually i forgot), and tried to give command by mach3 software.
4. soon the led of drive turned red. and i was afraid i have done somthing wrong
5. so i switched off everything.
6. i again restarted and the led still shows red.
my doubt is , whether the drive is damaged due to this. or i connect motor and start doing work again.
please guide me as i am a beginner.