I guess I will just have to change the G99 to G98 manually, does anyone know how to make it automatically post to G98? Thank you for the clarification MikeTheG.
Results 1 to 8 of 8
Hybrid View
-
11-01-2013, 07:35 PM #1
Registered
- Join Date
- Sep 2013
- Posts
- 9
-
11-01-2013, 09:18 PM #2
Registered
- Join Date
- Jun 2008
- Posts
- 1838
Try opening your PP in Notepad and look for the lines that control the G98/G99 output shown below :-
Originally Posted by Jbrown74
515. Output G99 instead of G98 in drilling? y
516. Output G98/G99 in drilling? y
I believe changing the "y" to "n" in line 515 should do it.
Remember just "Save" the PP after modifying, do not do a "Save as" or the PP will just be saved as a txt file and not a MillPst file.
Regards
Rob
:rainfro: :rainfro: :rainfro:
Reply With QuoteSimilar Threads
-
adjusting feed plane to allow rapid move
By bobcad guy in forum BobCad-CamReplies: 29Last Post: 05-13-2013, 02:06 PM -
Drill Cycle Rapid Plane B769
By seal1966 in forum BobCad-CamReplies: 6Last Post: 10-17-2012, 09:41 PM -
Drill Cycle Pecks from Rapid Plane
By Miksak in forum BobCad-CamReplies: 3Last Post: 01-26-2012, 06:18 PM -
looking for way to skip rapid plane in surfcam
By bigtown in forum SurfcamReplies: 8Last Post: 09-03-2009, 07:18 PM -
cycles initial plane/retract plane
By HuFlungDung in forum OneCNCReplies: 25Last Post: 06-27-2003, 01:02 AM
Posting Permissions
