I don't have a workable haas lathe post...anyone have one available?
I don't have a workable haas lathe post...anyone have one available?
ok so I was frustrated with the way surfcam was posting with the lathe post. So I finally read up a little on the posts and found out what was going on. The post was outputting -X moves instead of positive X moves. So I found that you could mod that by the RevSign in the post. problem solved via rbest again...lol
NOBODY HELPS ANYONE HERE... I NEED A POST TOO FOR A HAAS LATHE
Make one yourself, it is not that hard to
modify an existing post:
PostHASTE Formatting Reference Manual
What system is on the machine?
Hi guys just got a used SL10 in my shop. Any one can share the Post Processor for it would greatly appreciated.
i'm using MasterCam.
thank you!
[email protected]