[radeko]

Hello
Why does my mouse cursor get stuck in connecting to Fagor 8055T ?
I tested COM ports built-in ,and RJ-45 to RS-232 adapters, still without success, PC cursor freezes immediately
Still have the same problem, if anyone had the same? Thank you.

[CNCTech25]

Hello
Why does my mouse cursor get stuck in connecting to Fagor 8055T ?
I tested COM ports built-in ,and RJ-45 to RS-232 adapters, still without success, PC cursor freezes immediately
Still have the same problem, if anyone had the same? Thank you.

What operating system are you running on your PC? Are you using WinDNC to communicate? Also, do you have a physical serial port on the computer or are you using a USB to Serial ?adapter?

[radeko]

Thank You CNCTech25
I use built-in serial port Toshiba Satellite laptop and another Sony laptop with a USB adapter to Serial . Both of them stop my mouse cursor immediately when connected to a 8055 controller.
Windows XP Professional Service Pack 3 , WinDNC 5.2

[CNCTech25]

Thank You CNCTech25
I use built-in serial port Toshiba Satellite laptop and another Sony laptop with a USB adapter to Serial . Both of them stop my mouse cursor immediately when connected to a 8055 controller.
Windows XP Professional Service Pack 3 , WinDNC 5.2

WinDNC on XP should be no issue. What baudrate are you trying to communicate at? They have to match on the control and WinDNC, I've seen it where the program locks up for a few seconds if they do no match.
Is your RS232 cable to the specs of the pinout in the manuals?
I'm not too sure about the usb to serial adapter, never had any luck with those before as most of them are junk.