Has anyone found a source for the data entry push buttons for the Automec CNC300 control? The body is about 17mm square and the button fits through a 1/2" hole. It has 2 NO contacts used in parallel.
Thanks.
Has anyone found a source for the data entry push buttons for the Automec CNC300 control? The body is about 17mm square and the button fits through a 1/2" hole. It has 2 NO contacts used in parallel.
Thanks.
I'm looking at some right now, coincidentally I was going through all the surplus items I have and thinking I should get rid of them!
I bought them for some equipment some time ago and haven't a clue as to make, there is 7 of them left, these have 4 N.O. contacts.
There is a Logo on them, but no manuf name?
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Yeah, funny looking logo. Do you want to sell any of them?
How many do you need, you can take all 7 for $20.00 +p/p if you want.
I found an old invoice in the packet, they were $5.88 ea at the time.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Yes, I'd like them. Could I also get the part# and manuf. info from your invoice. My email is: [email protected] Give me a total and an address and I'll send a check or can do paypal.
Thanks!
Email sent.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.