Is there a way to have all the tools in the tool library come out as tool # 1 with the length and diameter offsets also at #1 ?
Would this be done in the post processor or does every tool in the library need to be edited ?
Any help is appreciated. Thank
Thread: Mastercam 9 Tool Library
Results 1 to 4 of 4
-
02-22-2013, 06:29 PM #1
- Join Date
- Feb 2013
- Posts
- 23
Mastercam 9 Tool Library
-
02-22-2013, 07:17 PM #2
Gold Member
- Join Date
- May 2004
- Posts
- 4519
Probably easiest to edit the post.
-
02-23-2013, 09:12 PM #3
Registered
- Join Date
- Jan 2007
- Posts
- 64
Cheer up! At least you have a 'library'. Using BobCad...library with nothing on the shelves.
Do it in the post.
-
02-24-2013, 04:49 PM #4
Registered
- Join Date
- Feb 2011
- Posts
- 423
When I first started with MC many many years ago I had a knee mill.
The post processor was setup to call all tools #1 because all the tool changes were done manually. I dont know if that is possible in MC9 but
you must be very careful or you will end up with a lot of broken tools.
Reply With QuoteSimilar Threads
-
SprutCAM Tool Library tool numbers
By MichaelHenry in forum SprutCAMReplies: 10Last Post: 06-29-2016, 02:30 PM -
CNC Tool Library (Creation of ISO 30 Tool Holders)
By ender_wiggen in forum SolidCAM for SolidWorks and SolidCAM for InventorReplies: 4Last Post: 01-27-2012, 08:59 AM -
Mastercam tools library
By basim in forum Post Processors for MCReplies: 1Last Post: 12-14-2009, 12:15 AM -
Mastercam library downloads?
By Nate0918 in forum MastercamReplies: 4Last Post: 11-19-2008, 01:33 AM -
tool library...or is it?
By brooklynmetal in forum BobCad-CamReplies: 2Last Post: 06-16-2008, 07:34 PM
Tags for this Thread
Posting Permissions
