[GACH]

Right after I made the original post, I thought about that. I've somewhat gotten it to work, but it'd still be nice to know if it's possible without it being an alarm.

Thank you,
GACH

[christinandavid]

#3006 can be used on a FANUC instead of #3000, allowing operation to continue without reset.

I am intrigued to know if you have found a way to display the actual value on screen as part of a message, as it does not seem to be possible on FANUC.

I usually move to a corresponding position after probing to display the figure on screen. It would be nice to have a more sophisticated method...

DP

[txcncman]

Right after I made the original post, I thought about that. I've somewhat gotten it to work, but it'd still be nice to know if it's possible without it being an alarm.

Thank you,
GACH

In your first post, you specifically asked to be displayed as an alarm.

Other options might include some macro programming to display and stop with an M00.

[Matt@RFR]

(PROBE BORE)
(CHANGE TO NEXT TOOL)
G90 G54 G0 X#188
M0
(X POSITION DISPLAY = BORE DIAMETER)

[GACH]

In your first post, you specifically asked to be displayed as an alarm.

Other options might include some macro programming to display and stop with an M00.

Just to clarify, I didn't specifically ask for it to be an alarm, I stated that it wouldn't matter if it was an alarm or a message.

Anyhow, I've played around with the functions abit and come up with a couple of cool ideas, once I've tested them properly I'll share them.