Is it possible or not to make a single point thread longer then the guide bushing without mismatch on middle of thread.
Machine STAR SA-12 with sub and a axis
FANUC 18i-T
Cut thread for example :
#10-32 2a
thread length 2."
material 303 ss
Do you know a way to lead-in in the middle of thread
Tried G76
First G76 starts before Z-0.0625
end Z0.4375
Second G76 starts at Z0.375
end Z0.875
and continue till 2"
--------------------------------------
Tried G32
First line G32 lead in \
second line G32 feed ______
Third line G32 feed out /
Is there a parameter that controls G76 cycle to lead in in correct spot
Thanks