[chiefcnc]

Hi, I have been trying to find 2 flute carbide endmill with centre cut/square cut to cut through 18mm mdf. Problem is i need them to be of 2mm to 3mm in diameter and have a cutting length greater than 18mm with down cut spiral.
Any links would be appreciated. Cheers.

[txcncman]

Did you check Harvey Tool?

[chiefcnc]

Just checked out harvey tool but only found 3 flute small diameter endmills with a cutting depth of 0.7500". I have only used 2 flute on MDF and would like to know if 3 flute give good overall results before purchase.

[chiefcnc]

I was thinking a 3 flute endmill will bind up when used on MDF. Anyone know where i can get downcut 2 Flute endmills with a LOC of 18mm or greater in a cutting diameter between 2mm and 3mm?
I have looked everywhere with no luck.

[riche543]

I know these guys have some deep reach bits. http://www.precisebits.com/




Sent from my iPhone using Tapatalk

[victorofga]

on ebay drillman1 seller has a good selection..

BARGAIN BIN, NEW CARBIDE PCB DRILLS items in CARBIDE PLUS store on eBay!


for non us seller

ER20 3.175mm 1 8 Spring Collet Chuck Bit Holder CNC Engraving Engraver Router items in Y-square Store store on eBay!


i buying from these sellers.. but ebay has always good deal..