hi all me again (problem man :bs: )
i have pminmo's http://pminmo.com/discrete/discrete.htm unipolar driver card
and bob card (interface card) http://pminmo.com/4axis/4axisinterface.htm
i hook them like the picture. pminmo helped me i did what he says and i can give little steps(manual) to the stepper. but i couldnt control the stepper from pc?
i try turbocnc and mach2/3 but i coudlnt make it.
i read and watch the tutorials but i couldnt setup it up i think?
could anybody (group) help me.
i am in trouble.
:drowning: