DEAR ALL,
FACING ALARM: LS 924 = 0 WARTEN AUF TUER GESCHLOSSEN. MACHINE IS HMC - MAKINO MC 50.
FANUC 15MB CONTROLLER , PL HELP ME TO SOLVE PROBLEM. I DON'T HAVE ELECT DRAWING. WHAT IS THE MEANING OF ALARM.
THANKS
RAJESH:drowning:
DEAR ALL,
FACING ALARM: LS 924 = 0 WARTEN AUF TUER GESCHLOSSEN. MACHINE IS HMC - MAKINO MC 50.
FANUC 15MB CONTROLLER , PL HELP ME TO SOLVE PROBLEM. I DON'T HAVE ELECT DRAWING. WHAT IS THE MEANING OF ALARM.
THANKS
RAJESH:drowning:
that is German and means: WAITING FOR THE DOOR TO BE CLOSED.
limit switch 924 is open.
You can change the control display language to English.
Thanks for the reply sir memoryman.
There are 3 door signals
1 = Operator door ( input checked = 1 its working )
2 = ATC door ( input checked = 1 its working )
3 = Pallet door ( input checked = 1 its working )
I do not have electrical drawing but all old makino machines have Limit Switch name / used for same purpose.
Machine do not show the ladder.
Don't know how to proceed further.
Pl tell how can I change the language.
thanks & regards.:stickpoke
Maybe a door closed confirm button? When it is not an automatic door, this is sometimes used.
Put parameter 2206 to 00000000 and 2205 to 00000100 for English display. Right now your parameter 2205 would be 00010000 for German display.
You can change the control's displayed language depending on software version), but the plc messages probably cannot be changed. If the plc is of the Fanuc built in variety, you should be able to display the ladder. That may have to be enabled in the plc.
Hi Rajesh
For changing the language u may set 0.0=0 on Makino MPC2 Parameter page.for any further help call on 9890012798.
thx.
atul
cncrepair
Pune