I need a little guidance on where to start looking for the solution to this problem...
I started to cut out my machines replacement and found a problem with the finished result. The file was to cut out 2 identical parts, each part was orientated so it was on opposite sides of the table in one sheet 1200x600. The part that came out correctly was furthest from 0,0 side and the other was out by 1 -2 mm in sizing, in the positive direction (that is larger than the first), this part was closest to the 0,0 side of the table.
Both parts are identical in size in the dxf, infact that are mirrors of each other.
I have been racking my brains to try and figure out what may be causing this but am at a loss and I am hoping someone will turn a light on in my brain so I know where to start.
I am using Mach3 in MM mode, the drawings were converted from imperial by scaling them by 25.4. This resulted in some measurements being like X345.88798 if that makes any difference.
I am going to cut the same file with LinuXCNC to see if it makes any difference, clutching at straws I know......
Anyway, any ideas or pointers would be greatly appreciated....
Cheers
Bruce