587,482 active members*
3,442 visitors online*
Register for free
Login

Thread: need advise

Results 1 to 3 of 3
  1. 05-04-2012, 09:47 AM #1
    Otar
    Otar is offline Registered
    Join Date
    Apr 2012
    Posts
    0

    need advise

    Hello ! I'm new here and need an advice: I've got the notebook and PC. If necessary I could use my notebook for the artCam but as I have a huge monitor for the PC it would be much more convenient for me to run artcam on PC where is already installed mach3.
    what would be your advice?

    thanks
    Reply With Quote Reply With Quote
  2. 05-06-2012, 04:24 AM #2
    mkc2
    mkc2 is offline Registered
    Join Date
    May 2008
    Posts
    142
    You can have both programs on the same pc but don't have both open at the same time.
    On my pc it's seems to crash if both are open.
    You should close all programs before using mach3, any interference with mach3 will certainly ruin your job..


    Cheers
    Reply With Quote Reply With Quote
  3. 05-06-2012, 06:33 PM #3
    Otar
    Otar is offline Registered
    Join Date
    Apr 2012
    Posts
    0

    mks2

    thanks a lot
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. CNC Advise
    By groovyd in forum Hobby Discussion
    Replies: 2
    Last Post: 12-04-2011, 03:47 AM
  2. a little advise
    By DistortedDesign in forum Joes CNC Model 2006
    Replies: 4
    Last Post: 05-29-2010, 08:10 PM
  3. looking for advise
    By phill05 in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 0
    Last Post: 03-09-2010, 09:19 AM
  4. 1st CNC - Need Advise
    By gerryv in forum Benchtop Machines
    Replies: 2
    Last Post: 10-31-2007, 08:29 AM
  5. need some advise
    By joey1117 in forum Benchtop Machines
    Replies: 0
    Last Post: 09-02-2007, 03:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules