[iatemeself]

I need to mill my cylinder head .065" in order to increase compression, please contact me by leaving me a message and I'll contact you as soon as possible.

[gabedrummin]

How is this a 5 min job will take 30 min setup...And most shops have a 1 hour min......100.00 bucks min.....And if its a big head more

[iatemeself]

How is this a 5 min job will take 30 min setup...And most shops have a 1 hour min......100.00 bucks min.....And if its a big head more

I'm on long island

[beekeeper]

a 5 minute cylinder head job is never good and a good cylinder head job is never 5 minutes.

[gabedrummin]

I am not being mean ....I only want to convey that removing .065 from a head is a lot of material . Hech I am 47 it takes 5 mins to get up of my stool . After slinging steel for 34 years its hard to move anymore. Been working in the shop since I was 13 years old. I was always taught to do a job correct takes time .When you rush mistakes happen or you get hurt. Be profensinal do it right at a fair price...

[iatemeself]

haha yeah I hear you, I need someone around me, also might want to turn down a 1" crank to a 3/4" crank and maybe even mill a big block 13hp .065